Preview
| Author(s): | |
| Title: | Experimental evaluation of optimized strut-and-tie models for a dapped beam |
| Abstract: | Strut-and-tie modelling constitutes a powerful tool for the design of complex structural reinforced concrete elements. It has been proved numerically that strut-and-tie (ST) models obtained using structural optimization methods produce designs that are more efficient. However, to the best of the authors' knowledge, no experimental evidence of such results has been published. This paper presents experimental results for nine test specimens; five of them were designed using optimal models derived from a full homogenization structural optimization algorithm, and the remaining four using conventional ST models for comparison purposes. Although all specimens carry loads higher than the factored design load, specimens based on ST models derived using full homogenization with reinforcement parallel to the ties exhibit better structural performance regarding crack growth control, more ductile modes of failure and a greater increase in load capacity. |
| Source: | Structural Concrete 17 (2016), No. 3 |
| Page/s: | 469-480 |
| Language of Publication: | English |
I would like to buy the article
You can download this article for 25 € as a PDF file (1.46 MB). The PDF file can be read, printed and saved. Duplication and forwarding to third parties is not allowed. |
I am an online subscriberAs an online subscriber of the journal "Structural Concrete" you can access this article via Wiley Online Library. |
I would like to order "Structural Concrete"This article has been published in the journal "Structural Concrete". If you would like to learn more about the journal, you can order a free sample copy or find out more information on our website. |
Prices include VAT and postage. Prices for 2017/2018.
€ Prices apply to Germany only. Subject to alterations, errors excepted.
€ Prices apply to Germany only. Subject to alterations, errors excepted.